More about this product
VMZINC's Corrugated Wall Panels belongs to the rain-screen family (wall cladding installed on a ventilated air space). This self-supporting system can easily be installed on a non-continuous supporting structure. The VMZ sine wave profiles are installed on a metal framework fixed to the supporting structure (masonry or metal structure).
- The VMZ sine wave profiles provide increased freedom of choice and design through the play of light and shadow on the cladding.
- The panels are available in multiple dimensions, providing a variety of design possibilities and can even be perforated.
- Maximum Dimensions: 10'-00 long
- On Center: - 2.67'' W x 9' - 6'' H
- Corrugation Dimensions: 2.67” width x 7/8” height
- Convex R1 120” pre-fab
- Concave R1 120” pre-fab
- Convex R2 30” field
- Concave R2 30" field
- Panels Per Crate: 50
- Weight: 2.00 lb per ft2 installed
- Packaging: 50 per crate
- Available Colors/Finishes:
- PIGMENTO red
- PIGMENTO blue
- PIGMENTO green
- PIGMENTO brown
1.Examine substrates, areas, and conditions for compliance with requirements for installation tolerances, metal wall panel supports, and other conditions affecting performance of work.
2.Verify that substrate is plumb, sound, dry, smooth, clean, sloped for drainage, and completely anchored, and that provision has been made for wall drains, flashings, and penetrations through metal wall panels.
3.Examine primary and secondary wall framing to verify whether or not purlins, angles, channels, and other structural panel support members and anchorages have been installed correctly.
4.Prepare written report, listing conditions detrimental to performance of work of this section. Submit copy of report to architect.
5.Examine roughing-in for components and systems penetrating metal wall panels to verify actual locations of penetrations relative to seam locations of metal wall panels before wall panel installation.
6.Install metal wall panels in orientation, sizes, and locations indicated on the drawings.
7.Install metal wall panels plumb, level, square, true to line, and within installation tolerances.
8.Install metal wall panels perpendicular to girts and subgirts, unless otherwise indicated.
9.Anchor metal wall panels and other components of the work securely in place, with provisions for thermal and structural movement. Do not use a torch to field-cut metal wall panels.
10.Fasten metal wall panels in accordance with manufacturer’s instructions. Flash and seal metal wall panels with weather closure edges and at the perimeters of openings.
11.Install flashing and trim as metal wall panel work proceeds. Fasten flashings and trim around openings and similar elements.
12.Maintain metal wall panels in clean condition during installation.
13.Remove protective film within 90 days of installation.